Water Pressure Pump | Solar | 100W

A compact stainless steel electric booster pump for the household water-pressure problems that don't justify a full-size pressure pump installation — low mains pressure, sluggish solar hot water flow, or weak shower pressure at upper-floor outlets. Sits inline with your existing supply, adds pressure when needed, and stays silent when it isn't.

What a Booster Pump Does

A booster pump doesn't replace your supply — it adds pressure to it. Where a pressure pump is the primary water source for a tank-fed property, a booster pump is the assist for an existing supply that's underperforming.

Typical problems it solves:

• Low mains pressure at the end of a long supply run
• Sluggish solar hot water where panel-roof piping introduces head loss
• Weak upper-floor shower pressure in multi-storey homes
• Tap-water pressure boost for outlets distant from the meter

The pump's small footprint and quiet operation let it sit inline without dominating a laundry, plant room, or ceiling cavity.

Build

• Material: stainless steel exterior with copper, brass, and stainless steel internal components
• Power: 100W
• Voltage: 220V or 110V (selectable model)
• Pressure class: low pressure (boost rather than primary pressurisation)
• Operation: compact and silent

The stainless steel construction is more than aesthetic — for inline pump installations that sit in living spaces, plant rooms, or ceiling cavities, corrosion-proof stainless cladding prevents the rust streaks that mark out poorly-built pumps after a few years.

Typical Use Cases

• Household pressurisation — boost weak mains supply at the point of entry
• Water heater feed — improve hot water flow rate where supply pressure is the bottleneck
• Solar hot water systems — overcome head loss in roof-mounted panel installations
• Tap water boosting — improve flow at outlets far from the meter
• Pipe pressurisation — maintain pressure in dedicated outlet circuits

Where This Pump Fits

Not a replacement for a primary pressure pump on tank-fed properties — for tank pressurisation use the 380W self-priming pressure pump instead. Use this booster where the supply is adequate but the pressure is borderline.